摘要本论文以MoO2(acac)2为前驱体，采用不同管径的碳纳米管MHx为载体，利用浸渍+程序升温自碳化法分别制备了Pd/Mo2CMHx和Mo2C/PdMHx两个系列样品。通过对比发现采用先负载Mo2C后负载Pd的方案一获得的Pd/Mo2CMHx催化剂中Pd粒径较小（9.5nm），采用先负载Pd后负载Mo2C的方案二获得的Mo2C/PdMHx催化剂中Pd粒径较大（24.9nm）。
通过电化学循环伏安分析，在1MKOH和1M乙醇溶液体系中，对比Pd/Mo2CMHx系列催化剂对乙醇的电催化氧化电流发现，Pd/Mo2CMH8催化剂的循环伏安性能最佳，乙醇氧化峰值电流可达3.65mA；对比Mo2C/PdMHx系列催化剂对乙醇的电催化氧化电流发现，Mo2C/PdMH3催化剂的循环伏安性能最佳，乙醇氧化峰值电流可达13.75mA。尽管方案一获得的Pd/Mo2CMH3样品中Pd粒径较小，但方案二获得的Mo2C/PdMH3对乙醇的电催化氧化活性明显优于Pd/Mo2CMH3。
进一步通过线性扫描伏安、Tafel曲线分析，研究了Mo2C/PdMH3对乙醇的电催化氧化动力学发现，乙醇在Mo2C/PdMH3上的电催化氧化受pH值和乙醇浓度的影响，反应级数分别为0.7和0.5。6070
关键词：碳化钼；燃料电池；乙醇电氧化；Pd；碳纳米管
 Abstract
In this work, two series of catalysts, Pd/Mo2CMHx and Mo2C/PdMHx, are synthesized by impregnation + the temperature-programmed self-carbonization method using MoO2(acac)2 as precursor, and multi-wall carbon nanotubes with different diameter (MHx) as support. Pd particle size of Pd/Mo2CMHx is around 9.5nm, which is much smaller than that of Mo2C/PdMHx (24.9nm)By comparing the load after load Mo2C first Pd is found that the scheme obtained a Pd/Mo2CMHx catalyst in Pd particle size smaller (9.5 nm), USES the load after load Pd first Mo2C scheme ii Mo2C/PdMHx obtained catalysts in Pd particle size is larger (24.9 nm).
According to cyclic voltammograms analysis in 1M KOH + 1M ethanol solution,  the highest ethanol electooxidation peak current (3.65mA) is obtained on Pd/Mo2CMH8 catalyst in Pd/Mo2CMHx series catalysts; and in Mo2C/PdMHx series catalysts, the highest ethanol electooxidation peak current (13.75mA) is achieved on Mo2C/PdMH3 catalyst. Although the Pd particle size of Pd/Mo2CMH3 (9.5nm) is much smaller than that of Mo2C/PdMH3 (13.75nm), the ethanol electrooxidation catalytic activity on Mo2C/PdMH3 is much better than that on Pd/Mo2CMH3.
By linear sweep voltammograms and Tafel curve analysis, the kinetic of ethanol electrooxidation is influenced by pH and ethanol concentration. The reaction order of OH- and ethanol are 0.7 and 0.5, respectively.
Keywords：molybdenum carbide, fuel cell, ethanol electrooxidation, Pd, carbon nanotubes
 
目  录
1 绪论    1
1.1 背景    1
1.2 碳化钼Mo2C    1
1.3 直接醇类燃料电池及其原理    2
1.4 乙醇燃料电池阳极催化剂    3
1.4.1 乙醇阳极催化反应机理    3
1.5 阳极催化材料    4
1.5.1 Pt金属催化剂    4
1.5.2 Pd金属催化剂    4
1.5.3 Pd合金催化剂    5
1.5.4 Pd及金属氧化物催化剂    5
1.5.5 其他催化剂    6
1.6 催化剂的制备方法    6
1.6.1 浸渍法    6
1.6.2 微波化学法    7
1.7 催化剂载体    7
1.8 研究课题的内容及其方案    8
1.8.1 研究课题内容    8
1.8.2 研究课题方案    8
2 实验部分    9
2.1 实验样品与仪器    9
2.1.1 试剂与气体    9
2.1.2 仪器    9
2.2 实验步骤    9
2.2.1 制备Mo2CMHx    9 Mo2C饰Pd基催化剂的制备与性能:http://www.youerw.com/cailiao/lunwen_3415.html