单相并联型有源电力滤波器的研究
时间:2022-12-01 21:43 来源:毕业论文 作者:毕业论文 点击:次
摘要随着科技和社会的不断发展进步,谐波问题越来越受到人们的关注,人们在对用电的质量和能效上有了更加高的要求。有源电力滤波器(APF)是解决谐波问题的电力电子器件,在提高电能质量方面扮演着极为重要的角色,其中并联型有源电力滤波器占据了主导地位。相对于三相有源电力滤波器,国内外对于单相有源电力滤波器的关注较少。然而,单相有源电力滤波器在实际使用中,有着很大价值,因此对单相有源电力滤波器投入更多的研究就显得尤为重要。86365 本文对并联型有源电力滤波器的各个方面作了详细研究,主要是在谐波检测上做了详细探讨,而对谐波的控制仅作了简要的分析与讨论。 文中,首先介绍了谐波的产生、危害和研究意义,国内外所规定的谐波标准和主流的谐波抑制措施。接着,介绍了目前比较重要的并联型有源电力滤波器的结构,并在给出原理图的基础上,对工作原理进行了简要分析。然后,对几种检测谐波的方法进行了介绍,并且重点分析了瞬时无功功率理论,验证了该理论在单相并联型有源电力滤波器上的正确性。之后,对该方法进行了一定程度的改进并加以验证。接下来,对谐波控制方法做了简要介绍。最后,利用Matlab仿真模块进行了建模,对有源电力滤波器的谐波检测方法做了验证,并进行了分析。仿真结果表明,本文设计的单相并联型有源电力滤波器在检测谐波方面达到了设定的目标。 毕业论文关键词:单相并联有源电力滤波器;瞬时无功功率理论;谐波检测 Abstract With the continuous development and progress of science and technology and society, more and more people pay attention to harmonic problems, it is the quality of electricity and energy efficiency have a more high demand。 Active power filter (APF) is a power electronic device to solve the harmonic problem,in the aspect of improving power quality plays a very important role, which held a dominant position in parallel active power filter。 Relative to the three-phase active power filter, less attention at home and abroad for single-phase active power filter。 However, single-phase active power filter in actual use, has a great value, so the single-phase active power filter to invest more research is particularly important。 In this paper, all aspects of the shunt active power filter have been studied in detail, mainly makes detailed discussion on the harmonic detection, and control of the harmonic only makes a brief analysis and discussion。 This paper first introduces the harmonic generation, harm and research significance, harmonic standards and mainstream harmonic suppression measures required by domestic and foreign。 Next, the paper introduces the current structure of the parallel active power filter, and gives a brief analysis of the working principle on the basis of the principle diagram。 Then,several methods of detecting harmonics are introduced, and the theory of instantaneous reactive power is analyzed, which verifies the correctness of the theory in the single-phase shunt active power filter。 After that, the method is improved and verified。 Next, the paper gives a brief introduction to the harmonic control method。 Finally, the Matlab simulation module is used to model the active power filter, and the harmonic detection method is verified, and the current after compensation is analyzed。 The simulation results show that the design of single-phase parallel active power filter in detecting harmonic reached the target。 Keywords: Single-phase shunt active power filter; Instantaneous reactive power theory; Harmonic detection 目 录 第一章 绪论 2 1。1 (责任编辑:qin) |