- 上一篇：顺流式填充床减阻英文文献和中文翻译
- 下一篇：冷却系统研究及注射模设计英文文献和中文翻译
The End Stop Finding Sequence starts when the POT parameter is selected, and the UP and SET push buttons (i.e. the two outside push buttons) are pressed simultaneously. The POT LED starts to blink, and the actuator moves steadily up scale from its set position. When its movement is stopped by the the top physical end stop, the positioner waits briefly, then moves the actuator steadily downscale until it runs against the bottom physical endstop, where again it waits briefly, and finally moves quickly back to the set position. The calibration data is written to non-volatile memory while the actuator pauses at its bottom stop.
If the positioner is in service on an application where excursions to the end stops will be disruptive, avoid initiating this sequence.
.安装
2.0 介绍
可提供直接安装型或现成直接安装型定位器可安装在Kinetrol旋转气缸上，或独立安装型定位器可以通过安装附件安装在任何90度的旋转气缸上。如果定位器是可以直接安装旋转气缸上，第2.1和2.2可以被忽略掉。定位器型Kinetrol旋转气缸有03至14型（可直接与定位器相配）。论文网
这些说明包括金属和成型反馈连接套的使用。而大部分的装置将包含一个成型连接套
2.1直接安装型定位器的安装