菜单
  
    摘要制备了环氧丙烷异构化的催化剂即碱性磷酸锂,采用原位红外技术研究了不同温度下环氧丙烷在催化剂上的吸附及反应行为,同时研究了在一定温度下环氧丙烷异构化产物在催化剂上的吸附行为。研究表明,环氧丙烷在碱性磷酸锂上于200℃以上才发生开环反应,温度低则不发生反应;环氧丙烷异构化产物丙醛丙酮中α-氢原子具有一定的酸性,它与碱性磷酸锂发生了化学反应,形成了一个共轭结构,致使羰基红外峰向低波数位移;在300℃下,环氧丙烷在碱性磷酸锂表面先进行吸附,然后形成带有醛基的中间体,最后生成产物烯丙醇。18977
    关键词  环氧丙烷  异构化  碱性磷酸锂  原位红外技术
    毕业设计说明书(毕业论文)外文摘要    
    Title  Study on the reaction mechanism of isomerization of propylene oxide catalyzed by Li3PO4
    Abstract
    The Li3PO4 catalyst for the isomerization of propylene oxide was prepared. The in situ FT-IR technology was employed to study the adsorption and reaction behavior of propylene oxide on the catalyst at different temperatures and the adsorption behavior of the products of isomerization of propylene oxide on the catalyst at a certain temperature. The studies show that the ring-opening reaction of propylene oxide on the Li3PO4 catalyst happens at a temperature over 200℃.When the temperature is less than 200℃, propylene oxide on the Li3PO4 catalyst is stable. The α-hydrogen atom of the products of isomerization of propylene oxide such as propaldehyde and acetone is acidic, which leads to the reaction of the α-hydrogen and the Li3PO4 catalyst. And it forms a conjugated structure, resulting IR carbonyl peak shift to lower wavenumber. At 300℃, propylene oxide on the Li3PO4 catalyst adsorbs first, then it forms to an intermediate with a aldehyde, finally the intermediate transforms into allyl alcohol.
    Keywords  Propylene oxide; Isomerization; Alkaline lithium phosphate; In-situ infrared technology
    目   次
    1 引言    1
    1.1 原位红外技术    1
    1.1.1 原位红外技术的概念    1
    1.1.2 原位红外技术原理与装置    1
    1.1.3 原位红外技术在催化剂方面的研究进展    3
    1.2 环氧丙烷异构化烯丙醇    4
    1.2.1烯丙醇简介    4
    1.2.2环氧丙烷异构化制烯丙醇的催化剂的制备    4
    1.2.3 环氧丙烷异构化制烯丙醇反应机理阐述    4
    1.3 课题的提出及研究内容    7
    2 实验    8
    2.1 实验材料    8
    2.1.1 实验试剂    8
    2.1.2 实验仪器设备    8
    2.2 实验内容    9
    2.2.1 碱性磷酸锂催化剂的制备    9
    2.2.2 环氧丙烷异构化生成烯丙醇的机理研究    9
    3 实验结果与讨论    13
    3.1不同温度下环氧丙烷在催化剂上的吸附    13
    3.1.1 300℃下环氧丙烷在催化剂上的吸附    13
    3.1.2 280℃下环氧丙烷在催化剂上的吸附    16
    3.1.3 250℃下环氧丙烷在催化剂上的吸附    18
    3.1.4 200℃下环氧丙烷在催化剂上的吸附    20
    3.1.5 100℃下环氧丙烷在催化剂上的吸附    21
    3.1.6 室温下环氧丙烷在催化剂上的吸附    23
    3.1.7 本节小结    25
    3.2 产物在催化剂上的吸附    25
    3.2.1 丙醛在催化剂上的吸附    25
    3.2.2 丙酮在催化剂上的吸附    27
    3.2.3 烯丙醇的红外谱图    29
  1. 上一篇:智能水基灭火器材关键技术研究
  2. 下一篇:环境矿物材料对巢湖水体及底泥中重金属固定效果的研究
  1. 天然沸石对水中磷酸根离子吸附研究

  2. ZnO/TiO2复合物的制备及光催化性能表征

  3. MoS2/TiO2复合物的制备及光催化性能表征

  4. ZnO/g-C3N4复合物的制备及光催化性能表征

  5. CuS/g-C3N4复合物的制备及光催化性能表征

  6. 生物质催化气化特性的研究

  7. MoS2/g-C3N4复合物的制备及光催化性能表征 

  8. C++最短路径算法研究和程序设计

  9. 上市公司股权结构对经营绩效的影响研究

  10. 中国传统元素在游戏角色...

  11. 高警觉工作人群的元情绪...

  12. 巴金《激流三部曲》高觉新的悲剧命运

  13. 浅析中国古代宗法制度

  14. g-C3N4光催化剂的制备和光催化性能研究

  15. 江苏省某高中学生体质现状的调查研究

  16. NFC协议物理层的软件实现+文献综述

  17. 现代简约美式风格在室内家装中的运用

  

About

优尔论文网手机版...

主页:http://www.youerw.com

关闭返回