菜单
  

    in a baffled stirred tank agitated with a 3-narrow blade hydrofoil
    CBY impeller and a Rushton turbine, respectively. They all con-
    cluded that LES is a reliable tool to investigate the unsteady behav-
    ior of the turbulent flow in stirred tanks.
    Albeit has the ability to study the mixing process, LES requires
    enormous amounts of grids and the wall-boundary layers need
    to be sufficiently resolved and therefore cannot be used in most
    practical settings [18]. DNS can capture all of the relevant scales
    of turbulent motion only if the mesh is fine enough to resolve even
    the smallest scales present in the flow. However, the turbulent
    scales can range from the smallest Kolmogorov scales to the largest
    scales the same dimensions as the object characteristic length.
    Therefore DNS require grids fine enough to capture the small ed-
    dies, but the computational domain must be extended to contain
    the large eddies. Accordingly, thismodel is computationally expen-
    sive and has largely been limited to simple geometries. For such
    complex turbulent flow problem in stirred tanks, DNS is extremely
    expensive and is currently intractable even on modern computers
    [8]. To the best of the authors’ knowledge, no comprehensive
    investigation of mixing characteristics in stirred tanks has been
    carried out by this technique so far. It is therefore essential to de-
    velop simulation techniques which can provide reliable mixing
    time data and with not so much computational cost. As an alterna-
    tive, the detached eddy simulation (DES) is adopted to investigate
    the mixing process in stirred tanks in this work. It is essentially a
    three-dimensional unsteady numerical algorithm using a single
    turbulence model, which functions as a subgrid-scale model and
    reduces the eddy viscosity in regions where the grid density is fine
    enough for LES computations, and as a RANS model in regions near
    solid boundaries, i.e. in the attached boundary layer, and where the
    turbulent length scale is less than the maximum grid dimension
    [19]. This model is also referred to as a hybrid RANS/LES model
    in that it combines the advantages of RANS and LES methodologies
    and can resolve the flow at less computational cost as well as with
    high accuracy [20]. Since its inception the method has been applied
    to a range of configurations including simple shapes such as
    cylinders, spheres and aircraft forebodies, in addition to complex
    geometries including fighter aircraft [21]. The fluid flow in a hu-
    manmouth–throat was also studied by DESmodel and good agree-
    ment with the LES data was obtained [22].
    It has been proved that eccentric agitation can improve the mix-
    ing in the laminar, transitional and turbulent flow regime. The
    eccentric position of the impeller lead to mixing time reduction
    with increasing the impeller eccentricity [23–27]. However, these
    investigations were all performed by experimental approaches. In
    the present work, an attempt is made to characterize the mixing
    of an inert scalar in stirred tanks equipped with four pitched-blade
    turbines using the DES model. To the best of the authors’ knowl-
    edge, no comprehensive investigation of mixing characteristics
    and assessment of mixing time has been performed by this model
    so far. The authors’ previous work [28,29] showed that DES model
    can predict the hydrodynamics of stirred tanks as accurate as LES
    does, can provide considerably improved predictions of the mean
    and turbulent quantities compared with those obtained by the
    RANS approach. This suggests that a better prediction of mixing
    time by DES model should be expected.
    The paper is organized as follows: Section 2 presents the stirred
    system geometry and the operating conditions. In Section 3, thegoverning equations, computational grid and numerical solution
  1. 上一篇:夹具设计研究与应用英文文献和中文翻译
  2. 下一篇:PLC可编程控制器英文参考文献和中文翻译
  1. ZigBee-RFID混合网络的节电英文文献和中文翻译

  2. 双位错叶片涡轮桨搅拌釜英文文献和中文翻译

  3. 混合视觉伺服英文文献和中文翻译

  4. 搅拌釜反应器英文文献和中文翻译

  5. 单螺带桨叶与双螺带桨叶...

  6. 固液搅拌罐的CFD模拟英文文献和中文翻译

  7. 搅拌和搅拌反应釜英文文献和中文翻译

  8. 上市公司股权结构对经营绩效的影响研究

  9. 浅析中国古代宗法制度

  10. 中国传统元素在游戏角色...

  11. 高警觉工作人群的元情绪...

  12. C++最短路径算法研究和程序设计

  13. 现代简约美式风格在室内家装中的运用

  14. g-C3N4光催化剂的制备和光催化性能研究

  15. 江苏省某高中学生体质现状的调查研究

  16. 巴金《激流三部曲》高觉新的悲剧命运

  17. NFC协议物理层的软件实现+文献综述

  

About

优尔论文网手机版...

主页:http://www.youerw.com

关闭返回