ABAQUS/CAE弹丸挤进过程分析
本文针对某型火炮弹丸在挤进过程中带有过盈摩擦、大应变率接触的问题，建立了弹丸挤进仿真的有限元模型，通过CAD软件建立三文模型，并利用大型仿真软件ABAQUS/CAE采用动态显式算法仿真研究了弹丸在挤进过程中的动力学参数，获得了不同材料下弹带的应力应变云图、弹丸的挤进速度、挤进阻力曲线，并分析得出了相应的变化规律，为弹带材料的选择提供合理的参考依据。
关键词：弹带 挤进 材料 有限元法
毕业设计说明书（毕业论文）外文摘要
Title Process Analysis projectile squeeze
Abstract
Projectile pushing stage is a very important part of interior ballistic study, it is a complex process, and it involves various nonlinear problems such as geometry, material, boundary condition, the calculation time is huge, the projectile inertia card bore process belongs to a three dimensional transient impact contact problem, due to the limitation of the current experimental conditions, simply by experiment is very difficult to obtain accurate results.
Based on a certain type of artillery projectile in the process of squeeze into the interference with the friction, big strain rate contact problem, the projectile pushing the simulation of the finite element model is established, by CAD software to establish three-dimensional model, and by using simulation software ABAQUS/CAE projectile were studied using the dynamic explicit algorithm simulation in the process of squeeze into kinetic parameters, obtained under different material to play with the stress and strain contours, squeeze into velocity of the projectile, crowded into the resistance curve, and analysis the change law of the corresponding to provide reasonable reference for the choice of cartridge belt material.
Keyword：Band Squeeze Material Finite Element Method
目 录
1 绪论 1
1.1 研究背景 1
1.2 研究意义 1
1.3 研究方法的选择 1
1.4 国内外研究现状 2
1.5 研究内容 3
2 有限元法基本理论及分析软件简介 4
2.1 有限元法简介 4
2.1.1 有限元法原理简介 4
2.1.2 有限元法的特点 5
2.1.3有限元法分析流程 5
2.2 ABAQUS软件简介 7
2.2.1 ABAQUS软件介绍 7
2.2.2 ABAQUS的特点 7
3 弹丸挤进过程的有限元分析 8
3.1 弹丸挤进过程的模型 8
3.2 弹丸挤进有限元分析过程 9
3.2.1 网格的划分 9
3.2.2 模型材料选择 11
3.2.3 设置分析步骤 11
3.2.4 定义接触面和接触对 12
3.3.5 定义载荷及边界条件 15
3.3 有限元计算 16
4 结果分析 17
4.1 弹带应力应变、接触压力结果分析 17
4.1.1 弹带应力应变结果分析 17
4.1.2 挤进过程中的接触压力结果分析 19
下一篇：共振耦合无线能量传输系统优化设计