毕业论文

当前位置: 毕业论文 > 外文文献翻译 >
  • 换热器动力学英文文献和中文翻译

    The investigation of heat exchanger dynamics has been carried out. The three kinds of exchangers havebeen taken into consideration: the low power plate heat exchanger, the high power industrial heatexchanger and the model of heat exchanger....

  • 视觉控制机器人英文文献和中文翻译

    AbstractThis paper is concerned with the performance evaluation of theH= lter for the 2-D visual servoing of amoving target. The ecacyof the H= lter is validated experimentally in comparison with the Kalman lter, using an eye-in-hand coordin...

  • 钢筋混凝土框架英文文献和中文翻译

    ABSTRACTSteel bar fracture of reinforced concrete (RC) column under strong cyclic load has been tested. On the basis of the test results, the steel bar fracture of specimen is consid-ered as the very low cycle fatigue behavior and the calcul...

  • 依法行政建设法治政府的关键英文文献和中文翻译

    Law-Based Administration: The Key to Building a Rule of Law Government Abstract Law-based administration is a focal point as well as a difficult point in the implementation of the fundamental principle of governing the country according to t...

  • 流经填料床的气固两相流的流体力学和传热英文文献和中文翻译

    AbstractFlow of a gassolid two-phase mixture through a packed bed is relevant to a number of industrial processes such as heat recovery andfiltration of dusty flue gases, iron making in shaft reactors, gas purification, and sorption enha...

  • 医院空调英文文献和中文翻译

    医疗保健设施 空调在疾病预防和治疗.8.1 医院设施.8.2 空气质量.8.2 具体的设计标准.8.5 连续性的服务和能源的概念8.13 诊断诊所8.14 治疗诊所8.14 护理FA CILITIES8.14 设计理念和标准8.14 系统...

  • 建筑系统暖通空调能耗的影响英文文献和中文翻译

    In historical centres, the buildings are characterized by pitched roofs, sometimes not insulated, with lowthermal inertia and coated in brick tiles with low solar reflection factor. So, the attics show high energycosts for heating and cooli...

  • 冲压模具设计拉深起皱英文文献和中文翻译

    Wrinkling that occurs in the stamping of tapered square cups and stepped rectangular cups is investigated. A common characteristic of these two types of wrinkling is that the wrinkles are found at the draw wall that is relatively unsup- port...

  • 冲压模具的应力分析英文文献和中文翻译

    Abstract. Experimental and computational procedures for studying deflections, flit, and alignment characteristics of a sequence of stamping dies, housed in a transfer press, are pre- sented. Die loads are actually measured at all the 12 die...

  • 从经典ASP到ASP.NET英文文献和中文翻译

    Moving from Classic ASP to ASP.NET ASP.NET is Microsoft new offering for Web application development, innovation within ASP.NET have resulted in significant industry popularity for this product. Consequently there is an increased need for AS...

  • 首页
  • 上一页
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 下一页
  • 末页
  • 1341337