毕业论文移动版

摘要双层以及多层薄板的减重减振特性，已广泛运用于汽车零部件和覆盖件，本文首先分析了双层以及多层薄板盒件的国内外研究现状，然后基于有限元分析的冲压成形工艺研究方法，运用PRO/E和Dynaform有限元软件对双层方盒件冲压成形过程进行数字建模与动态仿真，运用单因素和正交试验探讨了模具圆角、内外板材厚度比、摩擦因素、冲压速度、压边力对成形结果的影响，研究了双层方盒件的冲压成形工艺，奠定了研究复杂几何形状零件的冲压成形工艺的基础。60327

毕业论文关键词： 双层板   方盒件    拉深成形    有限元分析

毕业设计说明书（论文）外文摘要

Title  Analysis and Optimization Of Two-tier Square Box Drawing Process Based on Finite Element Analysis                                            

Abstract

Because of the multilayer boards have weight loss and vibration damping feature, it has been widely used in automobile parts and cover. Firstly, the research status of multilayer boards is analyzed. Then based on the finite element analysis of metal forming processes research methods, by PRO/E and the finite element software Dynaform, the digital stamping process modeling and dynamic simulation of two-tier square box is carried out. Then using single factor method and orthogonal experiment, influences the forming results were found out by changing the die corner, thickness ratio of inside and outside plates, the friction factor, punch speed, and BHF. The two-tier square box stamping process was researched. The basic on researching the complex geometry parts stamping process was established.

Keywords：square box，two-tier board，drawing processing ，finite element analysis 

  目次

1绪论 5

1.1  研究目的和研究意义 5

1.2  国内外研究现状 6

1.2.1双层及多层金属板成形工艺的研究现状 6

1.2.2  国内外对方盒件及有限元分析的研究现状 7

1.3  本课题研究的主要内容 9

1.4  本文组织结构 10

2双层盒件成形及有限元分析的理论基础 11

2.1  双层盒件拉深成形的特点 11

2.2  材料模型的建立 12

2.2.1  模型建立的基础 12

2.2.2 板材选择的刚度问题 12

2.2.3 摩擦状况及控制 13

2.3  双层盒件成形的缺陷 14

2.4  解决措施 15

3．双层盒件的有限元建模 18

3.1  材料模型的尺寸确定 18

3.2  有限元模型的建立 19

3.3 刚性几何曲面和网格化 21

3.4  约束和载荷的施加 22

3.5  各因素的判据 24

4．单因素模拟试验分析 26

4.1  定量因素的计算确定 26

4.2  单因素的选择 (责任编辑：qin)