毕业论文移动版

摘要本文介绍了对小型液压泵站的设计，首先通过对液压系统调速方案、压力控制方案、液压回路以及液压动力源的分析与选择拟定出液压系统图。通过已知的工作压力和流量完成液压泵及油箱的设计与计算，然后对所需的液压元件进行选型。将所选液压元件通过板式连接安装在液压阀块上并通过设计和计算完成通路的设置与阀块的布局。根据不同油路対流速要求的不同计算与选用管件及液压辅件。最后，在液压系统性能验算合理的情况下，利用solidworks软件完成液压零件及其装配图的绘制，再将管路连接起来，实现对液压泵站的三维造型，完成小型液压本站的设计。63546

毕业论文关键词  液压系统图  液压阀块  液压性能验算  solidworks造型

毕业设计说明书（论文）外文摘要

Title       A design of small hydraulic pump station     

Abstract

This article describes the design of small hydraulic pump station, the first governor of the hydraulic system through the program, the pressure control scheme, the hydraulic circuit and hydraulic power source to work out the analysis and selection of the hydraulic system diagram. By a known pressure and flow hydraulic pump and tank to complete the design and calculation, and then hydraulic components required for selection. The selected hydraulic components connected through a plate mounted on the hydraulic valve block and complete the passage through the design and calculation settings and valve block layout. According to different requirements of different oil Outward flow calculation and selection of fittings and hydraulic accessories. Finally, checking the hydraulic system performance under reasonable circumstances, the use of hydraulic components solidworks software to complete its assembly drawing, and then piping connections together to achieve three-dimensional modeling for hydraulic pump station, complete the design of small hydraulic site .

Keywords  Hydraulic system diagram   Hydraulic valve block   Checking the hydraulic performance   solidworks modeling  

1  引言 1

1．1  液压泵站的组成、结构形式及工作原理 1

1.1.1  液压泵站的特点及组成 1

1.1.3  液压泵站工作原理 2

1.3.1  基本任务 3

2  制定基本方案和拟定液压系统图 5

2．1  制定基本方案 5

2.1.1  选择平衡回路 5

2.1.2  选择换向回路 5

2.1.3  选择换调压回路 5

2.1.4  选择卸荷回路 5

2．2  拟定液压系统图 5

3  液压元件的选择与专用件的设计 7

3.1  液压泵的选择 7

3.1.1  确定液压泵的最大工作压力Pp 7

3.1.2  确定液压泵的流量Qp 7

3.1.3 选择液压泵的规格 7

3.1.4 确定液压泵的驱动功率 8

3.2  液压阀的选择 10

3.2.1  阀的规格 10

3.2.2  阀的型式 (责任编辑：qin)